JR XR3/R133 receiver help needed..

[LasagnaCat]

Just purchased a used XR3 that came (of course) with this receiver, but the plug that's on the jr servo that came with it fits in the receiver both ways (brown/red/orange as well as 'upside down' orange/red/brown, it looks like someone did some cutting/trimming on the plug)... which is the correct order (going from right to left while looking at the receiver) for the wiring...? And lastly, just to double check.. red is +, brown is -, and orange is the signal wire in this (jr) case, yes?

Thanks
LC

[Railman]

It doesn't matter, as long as the red one is in the middle. If the servo response s backwards just flip the plug over.

[Gutter Ball]

When looking at the receiver so the words are the right side up..it's brown wire on the outside and orange on the inside.

[LasagnaCat]

Thanks guys... exactly what I needed!