What size of axl dose my T2 and GT have?

[malici]

I want to know this because I going to buy bearings for my GT RTR, and I might add CVDs to my T2.

Malici

[Railman]

You need 3/16 ID x 3/8 OD without a flange for the T2. They are the same front & back. Double check on the RTRGT though, someone posted that they had 1/4" bearings, but I think they're the same as the T2,T3 & FTGT. Just take a look at the rear axles of each (T2 & RTRGT), & see if they look the same...it'll be real obvious if it's 1/4".
An easy way to measure a round shaft is to use an adjustable wrench and adjust it to the axle shaft. Then remove & measure wrench with a ruler. Its not perfect but it comes in handy for a lot of things. Hope this helps.
;)

[ 05-26-2001: Message edited by: Railman ]