Need Help!

[kilrick]

Hey guys, I have a buddy that is looking for a throttle stop screw for his torq .16 motor. we both have been looking at our local hobby stores and also the web. unfortunately we see that it's been discontinued for awhile now as is the carburator. Would any of you know where we can get one, or is there a motor that can be swapped out for this? This is for a Duratrax Maximum ST PRO. any help would be greatly appreciated.

[skylineTT]

is it rotary carb? what size is it? give is the info and we can tell you what engines will go in it. if its discontinued like you say then most liely you wont find that part. we can however tell you what engine you can replace it with

[kilrick]

rotary carb. Size? 2 speed,2wd
http://www.duratrax.com/pdf/dtxc0090-sell-sheet.pdf
this is an ad for the car we found on the internet

[kilrick]

I dont know if this will help
Carburetor--------------DTXG0440
Throttle stop screw-----DTXG0810

[LD3Furious]

I dunno for sure, but the part #s appear to be the same...
http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXTU76&P=7

[LD3Furious]

Also, you can look through Tower's site. If you can measure the carb throat on the engine block, you can match it up to a carb listed on the site. Look in the Notes section of the description and they state the size.

[zakerid]

http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXTU69&P=Z
i would contact duratrax and see if this ^ screw would work. the p/n is DTXG0811 which differs from the p/m that kilrick found.