com look ok?

[josh222]

http://i142.photobucket.com/albums/r83/HpiJosh222/IMG_1774.jpg

rebuilding my Element 19t after a little brush mishap(my fualt)

http://i142.photobucket.com/albums/r83/HpiJosh222/IMG_1777.jpg

http://i142.photobucket.com/albums/r83/HpiJosh222/IMG_1778.jpg new ones in just need to remove old and solder new ones on

http://i142.photobucket.com/albums/r83/HpiJosh222/IMG_1779.jpg

[associatedude92]

You might want to cut it again. With all those gouges in the comm, I wouldn't run it until you cut it again. For the brush mishap, don't worry everyone makes mistakes.

[terrible-t]

Question yourself? How mant times you change the brushes? Twice? 3times? After three i would put the comm on the lathe. Depending on brush compound (hard or soft). More to it then just replacing brushes! huh!!

[B4 Stealth]

my experience with the revolutions is that those brushes can outlast the comm by 2-3 times. if you buy silver brushes than all you need to do is cut it. my buddy's v2 lasts a set of brushes all season, and he only hast to cut it 4 or five times.

[elecracr]

THe brushes do last a long time in those motors. I would definately have that comm cut because of all those gouges in the comm.

[rccardude04]

If you look REALLY close, there is a bit of hourglassing also.
I'd cut it...
-Eric