Iwata HP-CS .5mm Conversion...

[PoweredByNitro]

Hi, does anyone know what parts I need to do a .5mm conversion to my Iwata HP-CS??? part numbers too please. Thanks!! :D

[civicwil]

Here goes;
Nozzle Cap-#1602 1
Nozzle- #1604 1
Needle- #1617 1
Hope this helps.
Wil.

[PoweredByNitro]

thanks!! do you recommend that size for faskolor paints, metallics,pearls,glitters (maybe)??

[dyslexic]

I have the same brush and I've just received the parts for the conversion, although I have yet to try them from my experiance with the stock setup pearls & metallics are a royal PITA to spray without considerable thinning and glitter is just asking for trouble with the stock tip if you plan on doing a lot of glitter I would suggest getting a cheap single action brush that would be easier to clean out all of the clear and glitter residue.

as for regular faskolor you should have no trouble with the .5 tip you will still need to thin some paints more then others to get them to spray well and you will still have tip dry but over all it should make life a bit easier.

[civicwil]

I'm currently using this setup in my CS iand it seems to be just fine with the metallics and pearls. I do thin my paints using Auto Air 4011 Reducer.