C2 Problem

[Signal]

I have a C2 and today when running it the car just stoped!!! I thought a bad connection or a battery bar.. But when I removed the body from the car the LED was still on... Now when I hook up the battery the led will come on, but no steering or throttle.. So I turn it off and try to turn it back on but it will not turn back on :mad: What happened??? :confused: HELP

[bryceanator]

its some thing with the reciver or transmiter

[Signal]

I checked the radio gear with the battery pack that came with the radio { CXP2** and the servo works....

[bryceanator]

it must be lose conections did you check all of them motor esc it the plug in backwards? are all the wires at the tip of the plug?

[nsane]

You got further than I did.. I've got a new C2, fresh out to the box, wired it up and its flat dead.. all I get is a power LED. And I'm 100% sure the wiring, etc is correct. Oh well.. off to Novak it goes.

Thinking I should have got the LRP 7.1..

[rcracer_xxxt_futaba]

I got my C2 and I had the same thing happen. When I would turn it on it would just have the LED on but no steering. The problem was: 1. The plug was hooked up backwards in the Rx 2. I had to set the speedo (when the LED is on hold it down till it gets red then gevi it gas and then brake) Now my C2 has worked GREAT! I even convenced some of my friends to get one :) :D :cool: :cool:

[Signal]

The car has been working fine since 5-1-01.
It just quit working the other day in a race.

All the connections are right. The ESc
just quit. It gets hot just sitting there.

I sent it in hoping that it will be coverd by my 120 day warrenty.. This is the first product that I have ever bought from Novak and I am not impressed... HOpefully this will be resolved.... :D