PDA

View Full Version : Which home made discharger set-up?


teach
07-08-2001, 04:26 PM
I have read two set-ups but want to know if one is better than the other. http://www.balakracing.com/bulb_discharger.htm http://www.nascart.com/howtos.htm

teach
07-08-2001, 04:27 PM
Or should I just get the Deans? And where can I get the Deans Black Box? I can't find it any where.

Jason_R
07-08-2001, 04:33 PM
Deans has discounted the first black box. They are about to release the black box II. So you can only find the first one used. You can buy the racers edge one though (www.racers-edge.com) As for the other question i am in the same boat as you. Later

[ 07-08-2001: Message edited by: Jason_R ]

nsane
07-08-2001, 06:35 PM
I think either setup will work just fine, I don't know that one is better than the other. The only positive I see to the nascart one is that it will lower its draw as the batteries discharge, but if you are going to use a black box, etc it really won't matter as long as you cut them off before they go below the low voltage mark.