motor question!?!?!

[Viper7391]

i broke in my brushes correctly, but when i run my car i have to push it first, then it will go, and if i stop the car, it wont move unless i give the car a little push again. it frustrating, i cant figure out what iz wrong. but if you have any solutions then post them so i cant try and fix my car. thanks :confused: :mad:

[B3Tyler]

Hung brush. Take out your brushes and spray the comm and the brush hoods and wlean em out with like a q-tip or something. Hope this helps :D

[XXKlD]

im hiz older cousin, and i help him out with hiz r/c car. what should we spray it with? motor spray? what kind should we get? :confused:

[B3Tyler]

There almost all the same, buggy blast, Moter quencher. Spray out your moter, then take a q-tip and run it through the brush hoots and stick it in to its toucing the com and totate the oter a little http://www.contrabandent.com/pez/cwm/cwm3d/3dsmirk.gif

[XXKlD]

ok thanks.

[Nairb]

The most common thing to cause this is worn out brushes. First check to see if they've gotten too short to be pressed on the comm by the springs. If they still look good and long, then check the brush hoods for binding, like Tyler said.

[ATeam]

As far as motor cleaner to use. Go down to Checkers or almost any auto parts store and get some Electric Motor spray, not brake cleaner, but Electric Motor Spray. It will be where all the areosols are at. That is what I always used, and it is alot cheaper than the same thing in a can with Kinwald's name on it.

ATeam

[Viper7391]

ok thnx I'll try that

[Viper7391]

the brushes were still good length, my cousin came over and he cleaned the motor for me. now its working fine, and its fast again. its a reedy rage, 24degree stock motor. its still pretty fast. thanks for all your help. :D