Can this be right???????

[JoeTheShmoe]

Ok, i finally got my rc10b2 werking, and brought it up here and was driving it around the living room, and i sat down at the computer, and started up Easy RC 6 (a nice rc tool!) and i put in my pinion (17t) and spur (81) and selected my vehicle, (rc10 b2)
and it gave me a gear ratio of 11.44:1. I then put in my tire diameter im mm (273.05) And the rpm of my motor (i didnt know what to put..... it is a speedgems 14t double. The pink one.......<-- but i put in 25000 rpm, becuase it seems like that is what the p2k is. And it gave me a roll-out of 2.92 in/rev and a speed of 69.89 mph. The speed is what i cant belive is right!!! If this thing can go 70 with a novice guy like me, how can theguys at rcca miss 100 with a nitro.. Anybody know what i goofed on?

[DerekB]

Check you diameter....I don't think you have 10" tires! Makes a huge difference.

[LosiMan3456]

What is Easy R/C 6? Is is it a software? how much is it and where can I buy it at?

[B3 Bomb]

Where can you buy that software at?

[rvrrun]

Easy r/c 6 is freeware.

http://www.interlyn.com/easyrc/

[JoeTheShmoe]

Ya, Easy R/C is free off the enternet, and i took a tape measure and went around the outside of the tire and it said 10" and wheatever else i said. (i could be wrong of course!!!)

[doublet]

HEY!!!! Thats the circumference you measured!!! The diameter is the lenght of the face of the wheel. Place the wheel face down, then measure from one side of the middle to the other. Should be 2 inches or so

[cck]

The diameter for your B2 should be around 3.5"

[JoeTheShmoe]

Ok, after i finished my second post i thought if thats what it could be. Guess a 10" tire that way would be pretty huge, lol!

[JP]

BTW, is there a contact E-Mail for easy RC-6? I had the program for awhile, but I cant register it because of this program not supporting stupid AOL. Any way around this?