Hitec 645mg fit T3?????

[racin4ever]

i heard that they do, but i dont want to spend the money and not fitting and returning it again. if it doesnt does any know what metal gear steering servo does?? im getting really tired of breaking just one piece of my plastic gears and buying a whole kit

[RC10T3]

you need to fix your servo saver by cranking the knurled nut until it hits the top of the post, making the servo saver loose. Also, put black grease between the 2 halves. Then get a metal gear, or a servo with al least 60 oz of torque.

[ATeam]

It will fit. You may have to file down some of the chasis. Where the screw that holds the battery bar screws into. I know I had to do this to get a Hitec 605MG to fit in my T3.

As far as the servo saver goes. Get some very fine sandpaper, like 1000 grit and sand both halves of the saver. Get it to baby's butt smooth. Then smooth a small amount of black grease on it, just enough to say you did. Then set it up as per the manuel. This setup requires some maintenence, because the black grease will attract dirt so clean it after every race.

ATeam