Plase help me! Motors going in reverse and dont know why.

[mavrick0611]

Hey, what else can happen with me?!?!?!?!?! Ok i got my motor all soldered up red wire to positive black to negative, shotky diode on correctly and motor is running in reverse!!!! this has never happened before! what do i do? Solder the postivie to the negative and the negative to the postive???

what else?!?!?!
aj

[Car_Head12]

yeh something is reversed check all ur plugs, but first flip the throttle reversing switch on ur remote.

[Car_Head12]

double

[ 06-21-2001: Message edited by: Car_Head12 ]

[mavrick0611]

no, that would only cause throttle to break and break to throttle. any ways, i got it fixed. i searched through threads and some one had the som problem. i accidently put my endbell one wrong. i fliped it 180 degrees and it worked right.

Can some one explain why fliping the end bell 190 degrees makes it go in reverse and forward?
aj

[HowieStern]

like mentioned above..... check your servo reversing switch on your radio... and if that's not it...

double check to make sure you haven't reversed any wires between your motor and esc... and if that doesn't work...

you may have installed your endbell 180 degrees opposite of what it should be.... so you would need to rotate your enbell to the other side...

peace out.... :)

[Leet TC3]

Flipping the endbell 180 degrees is EXACTLY like wiring your endbell backwards...

[yankees2000]

I cleaned my motor out and the same thing happened...i just took apart the motor and rotated the can the the holes match up the opposite as when they were first put in.