Tools needed for xxx-nt?

[raz9]

What sizes of hex drivers do I need for the xxx-nt. Btw was looking at some integy Ti-Nitrade hexdrivers. Are they any good?

[evaderstman]

Integy drivers are great, but the only 0one i have ever broke was on an xxx-nt so take that into consideration.

[raz9]

But what SIZES do I need?

[evaderstman]

Look in your manual i don't personally own one, and it uses odd sizes compared to the other vehicles i have ran before. The one i broke was a 1/16" and it is used a lot on that car.

[raz9]

TOOLS REQUIRED
Team Losi has supplied all Allen wrenches and a special wrench
that is needed for assembly and adjustments. The following
common tools will also be required: Small flatblade screwdriver,
Phillips screwdriver, needle nose pliers, regular pliers, scissors,
or other body cutting/trimming tools. 3/16", 1/4", 5/16", and 3/8"
nut drivers are optional.

This is what the manual says. Is what they call "nut drivers" in the end, is that hex drivers they actually mean?

[Budman_222]

A nut driver is like a screwdriver except it has a socket end. Hex drivers have an allen wrench end. I prefer the hollow shaft nut drivers rather than the interchangable socket type. The interchangable ones are too shallow for me. It's your own prefrence, though. I know people who use both. Just don't get cheap when you get your hex drivers. Get a good set. The allen wrenches supplied in the kit are junk.