NH tuned pipe

[lnc321]

Hello guys I want to put a Macs tuned pipe on my hammer, would this one be the right http://towerhobbies.com/listings/cat-cat-g.html (http://) Also do I need a tune pipe adapter as well or will the stock one from the hammer be fine?

[lnc321]

Would this one fithttp://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXZ557&P=0

[CFRACR]

Would this one fithttp://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXZ557&P=0


Thats the right one! :D
You will need to cut off some of the header to make it fit in. About a 1/4 in worth if I remember right. Also yes you will need a better coupler. The stock one won't last 10 seconds after you put the pipe on. You can order one, or get a blue stack tube and cut a piece off. The blue stack coupler will last a looooong time. Then just pull tie tight like before. Thats it! pick to help out...

[lnc321]

Thank u CFRACR. Nice Hammer. Have u had any problems with that tank so far? I just got mine.

[CFRACR]

Thank u CFRACR. Nice Hammer. Have u had any problems with that tank so far? I just got mine.

No problems 2yrs+ & counting. :D

[yellow-hydro]

is that cylinder head off a dynamite .15?

[CFRACR]

is that cylinder head off a dynamite .15?

It is a Dynamite engine. :D

[yellow-hydro]

AAAHHHHHA,..... it did look familier. it must move pretty good.

[CFRACR]

AAAHHHHHA,..... it did look familier. it must move pretty good.


It does have great response & zip, & stays on the pipe like it should. Pretty much tuned out just right. For top end its about the same as the stock Aquacraft engine, just a better more reliable engine.