slipper clutch problem on my T3

[TC3Racer]

ok, i just got a new ESC for my T3 and i had it all set up and i tested it out... the slipper clutch was loose so i tried to tighten it up. the spring is pretty close to full compression but it still slips. whats up?

[rcguy49]

when you reasembled it did you srew your spur gear into that plate.if not this is the set up:first plate,gasket,other plate with the bearing that goes in the spur gear,spur gear attatched on the 2nd plates bearing,then a little black spacer with ball bearings in it,then spacer,spring,spacer.

[Andrew the RC man]

there is this pin and i think its a rubber thing that need to hook together alot of times when i re-assemble my T3s drive train i screw up on that so you might want to check it(sorry i can give you the exact names its just i dont use instructions when re-assembling things :rolleyes:

[TC3Racer]

thanks for your replies guys but i found out that its just my diff. that was loose. thanks anyway.