MIP CVD's

[doby]

I have MIP CVD's on my RC10GT with 1/4 inch axles and I just want to know if I couuld put 3/16 axles on them with the same dogbone half. So basiclly I just want to switch the axle end of the cvd's instead of buying new cvd's. If you understand my question please let me know..

[jeepinator]

Yep, that should work.

Anyone else ?

[speedydave]

I am pretty sure that will work, however you would need new rims and bearings to fit the new axles, unless you are buying the axles to fit the bearings you have.

[Railman]

Doby, I'm sorry it took me so long to reply. I started to reply earlier, but then I wanted to actually measure each one out to be shure. They are the same length & should match up perfect. You just need the 3/16" MIP axles & the std Assoc hub carriers with 3/16 x 3/8 bearings. The FTGT's come with 1 1/2' hubs & 3' blocks, & I would highly recomend them for off road. Funny thing is I also need to do this to my old tub GT. ;)
Joe

Almost forgot, Daves right about the wheels. The 1/4" ones won't fit the 3/16" axles, but you probably knew that anyway. Joe

[ 09-08-2001: Message edited by: Railman ]

[doby]

Thanks for the help guys. Now I only have to spend 8.00 instead of 30.00. :cool: