reciever help!!!!!!!!!!!!

[guff20]

Hey Dudes!! :cool:

I need help finding the pinouts of my hitec
hfs-03mc receiver (3 channel fm). I need to know left from right what pin is signal,ground,and power. I need to know this because I am piecing together a radio system from three manufacturers for my xxxt. I bought it used so no documentation was acquired. Any help would be appreiciated!!!!!!!!THANKS DUDES!! :p

P.S. I tried thier website, it was no help!!! :mad: :eek: :( :confused:

[Railman]

Guff, the important thing is that the red wire goes in the middle. The other two can be reversed with the result being that it merely reverses the direction of the servo. The only exception to that in the major RC brands is the OLD Airtronics equipment . They had the red wire on the outside which made it very confusing & dangerous to combine different equipment. They finally resolved that issue with the new Airtronics Z connectors. They are totally compatible with the industry std...red wire in the center. Hope this helps. ;)

[guff20]

thanks for the info.. what you said would have worked if the reciever was not defective!!

the reciever that came with the new hitec lynx fm radio system was defective....junk.....

so i am using a 10+ year old futaba am radio and reciever that works just fine...


the lynx radio system will be sent back and a new futaba one will take its place!!

[rims']

futaba recievers rule. they are tuff