Futaba 2PC

[BrahmaBullSQ]

alright... i just recieved it from tower hobbies today and i hooked everything up to make sure it was ok. it was raining so i had to run it inside. the normal throttle position makes me push the trigger up to go. i have an explorer 2 so there's no reverse. and when i put the throttle position switch to reverse so i can pull the trigger back instead of pushing it forward and it goes berserk and just floors it. is there anyway i can make it so i can pull instead of push??? please help. maybe that's how its supposed to be but i don't like it. thanks. http://www.rccaraction.com/ubb/smile.gif

[jboyce13]

that is not how it is supposed to be. i was going to tell you to use the servo reversing switch on the controller, but i saw that you did that. check the crystals, make sure the servos i plugged in correctly. could be a faulty controller, crystal, or receiver. just my guesses. hope it helps http://www.rccaraction.com/ubb/smile.gif

[Nairb]

Duh, guys (no offense!). Flip the servo reversing switch and reprogram the ESC before it runs off. Turn on the radio, hold the car in your hand, turn on the ESC and push the "set" button. The motor will stop, you will set the ESC, and everything will be just peachy.

[Nairb]

You know what else? You could probably just reset the ESC without reversing the servo and it will work fine. Either way, it's a SUPER easy fix.

[BrahmaBullSQ]

thanks guys. i'll do that.