Cirrus CS60BBMG any good?

[RustlerBoy]

I just broke my stock servo on my T3 and just ordered that. Is it any good.Or was it a waste of money?

[ZenLosi]

I got one and it works really well. Cirrus servos are great values IMHO.

Also, you may want to fix that servo saver in your T3. T3s are notorious for tearing up servos if don't take some of the friction out of the servo saver.

-Zen

[Obi112]

Yes, for the money, it is the best servo, bar none. You'll probably have a tough time fitting it in the T3. No worry, just file away some material wherever it hits.

[malici]

Where can you buy them?

Malici

[RustlerBoy]

Get them at http://www.hobbypeople.net for $22. What should i do to take some friction out of the servo saver and how hard is it going to be to fit it??

[beeper]

I don't think that servo will fit in your T3. My LHS tried to tech a guys T3 and replace it with that servo. Didn't fit. But I got a new servo out of the deal.

[draggerman11]

My friend has one in his T3. You just have to shave a little of the plastiv away from the chassis.

[Obi112]

It's very easy to fit. File away a millimeter of the spot where the battery hold-down screw is threaded. It's well worth the minute effort because of the servo's value.

[RustlerBoy]

So, it WILL fit? I hope it does!

[rims']

i put it in my t3 and it fits fine you will need to use the spacers for tha mounts though

[RustlerBoy]

All right, sweet. Do you put them where the servo meets the chassis, ir where the servo meets the mounts?

[rims']

where the servo meets the mounts

[RustlerBoy]

Well, it works! It cuts out some times and it doesnt make the wheelsturn as shadrp as with me stock servo!

[rims']

trust me u will not have any problem with that servo. i tested it with some of the hardest bashing you ever saw i broke my front bulkhead and top plate but the servo is as tough as nails good choice with the cs-60, yes it is a little slow but it is strong