Will this setup work?

[jordanxt]

I finally got the gws pico pack in the mail after a long delay. Its been keeping me from getting the Tiger Moth in the air, so I was overjoyed when it arrived. I opened the box only to find that the receiver(futaba shift) that I ordered was accompanied by 2 JR shift servos and a JR shift esc. Dang! Will this work as is, or will I need to cut and solder wires... or replace the servos and esc all together with ones that are futaba shift? :confused:

Has anyone else had this happen?

Thanks!

[mike nill]

as long as you make sure the polarity is right theres nothing wrong with this setup.

[pfg]

servos and esc's are not "JR" or "FUTABA" shift. only the receiver is sensitive to this. so long as you have either futaba or another "positive" shift transmitter it will all work fine. you do have to check the order of the wires on servos and esc's. as far as i know (all of mine are) the GWS receiver has the standard order of nevative, positive, then signal on its connectors. the signal wire is closest to the receiver, negative is on the outside.

[jordanxt]

Thanks! It's all good now.